Remote Control Programming

Entone URC Plus

Entone URC Plus

Registration with Hydra

Press and hold the “OK” button on the Hydra front panel for approx. 5 seconds. When releasing the “OK” button, the Hydra front panel will display “RCREG”. The Hydra is now in remote registration mode.

On the URC PLUS, press and hold the “STB” button for approx. 5 seconds. The “STB” button backlight will illuminate. On the URC PLUS, press “STB” once again. Both the “STB” and “AUX” button backlight will illuminate.

Select the decoder to register by:

  • Press “1” to register URC PLUS to decoder 1
  • Press “2” to register URC PLUS to decoder 2
  • Press “3” to register URC PLUS to decoder 3

After you enter a registration event, the “STB” button backlight on the URC PLUS will blink twice to indicate that the registration process was successful. The Hydra front panel will display “RC REG Dx” to indicate that the registration process was successful.

Pressing a key other than “0”, “1”, “2”, “3” or a button is not pressed within 10 seconds, the “STB” backlight will extinguish and the URC PLUS registration process will be terminated.

If the Hydra does not receive any URC PLUS registration event within 30 seconds, the process will be terminated.

TV Auto Search

  • Turn on your TV
  • On the remote control, press the TV mode key once
  • Press and hold the “Setup” key until the TV key blinks twice, then release “Setup”. The TV key will light up
  • Press the “POWER” key once
  • Aim the remote control at the TV. Press either the “CHANNEL UP” key or “CHANNEL DOWN” key to do device auto-scan
  • If the TV turns off, a working code has been found. Press OK once to lock in the code

Remote Assistance

Disclaimer text for support application. "Service(s) are provided in an effort to fix, upgrade, or otherwise repair the computer system(s) for which client or authorized representative requested such service(s). Your system will not be intentionally harmed. The primary goal is to fix your computer or systems, not create or cause further damage. In the case of accidental damage of data to your system or data loss caused by already existing problems in your system such as viruses, bad configured software, or hardware problems/failures, Client agrees not to hold South Central Rural Telecommunications Cooperative and any person(s) associated with South Central Rural Telecommunications Cooperative responsible for damages resulting from such problems. It is the Client’s responsibility to backup data. South Central Rural Telecommunications Cooperative will not be responsible for data loss. Please not that the above-shown disclaimer has no connection with TeamViewer GmbH. It was individually defined by a TeamViewer user."
Screenshot of the support tool terms of use.
support application connection details screen
Screenshot of the the support tool connection details screen.